- New
Connecting hose for 6 m³/h filtration kit – Emaux (01370011) images
Connecting hose for 6 m³/h filtration kit – Emaux (01370011)
Flexible connecting hose for Emaux 6 m³/h filtration kit
This black connecting hose is the genuine Emaux part, reference 01370011.
It forms part of the Emaux 6 m³/h above-ground swimming pool filtration systems.
It connects the pump to the filter and allows water to flow between the two.
Its corrugated central section is flexible: it compensates for any slight misalignment between the two fittings.
It is fitted using the two nuts already in place, one at each end.
Simply screw them on by hand to the pump and the filter.
Dimensions: length 280 mm, external diameter 55 mm, internal diameter 45 mm.
Compare these dimensions with your old hose: they are also shown in the last photo.
Ideal for replacing a split, crushed or leaking hose, without having to change the whole kit.
Description
The connecting piece for your filter unit
In a filtration kit, the water flows out of the pump and into the filter.
This hose connects the two units.
If it is split or not tightened properly, the kit will leak and the pump may draw in air.
Specifications
- Brand: Emaux, manufacturer’s reference 01370011.
- For a 6 m³/h filtration kit.
- Length: 280 mm.
- Outer diameter: 55 mm.
- Inner diameter: 45 mm.
- Flexible corrugated hose, made of black plastic.
- Two coupling nuts, one at each end.
Compatibility
This hose is the original connection for Emaux 6 m³/h filtration kits.
Check the flow rate specified on your kit before ordering.
Replacing the hose
- Switch off the pump and disconnect it from the mains.
- Close the valves or plug the pool pipes.
- Unscrew the two nuts and remove the old hose.
- Check the condition of the seals on the pump and the filter.
- Fit the new hose and tighten the nuts by hand.
- Switch the system back on and check for leaks.
ℹ️ Good to know: check the dimensions against your old hose before ordering.
The dimensions are shown in the last photo.
⭐ Tip from the team: tighten the nuts by hand, without using a tool.
Tightening them too much can damage the thread or crush the seal.
-
Brand
-
ReferenceEMX-101-0071
-
In stock8 Items
-
EAN133661145019950
-
Manufacturer's reference01370011
-
ColorBlack
8 other products in the same category
Viewed products
- New
- Out-of-Stock
